TOP > Adjusting the Product > Flow of Printing Operations > Operations for RFID Write (RFID Models Only) > RFID Writing with Cut & Print Mode RFID Writing with Cut & Print Mode If you selected cut & print mode, the RFID is encoded before printing while printing is stopped at the print head position. When in cut & print mode, you cannot use the RFID Tag Offset. Even if you have set the Tag Offset, the set value is ignored. Furthermore, when cut & print mode is set, the RFID tag error print is same as the error print in continuous and cutter mode. *1 After printing, if the next data is received, printing will be done and the media will be cut on the cut position. *2 After printing, if the next data is not received and the waiting period for Eject Cut has passed, Eject Cut will be performed. *3 The EPC code write <IP0> command writes data at this inlay position. In addition, the RFID read [DC2]PJ, print tag data <TU>, and EPC/TID return <RU> commands acquire information at this inlay position. • The figure above shows the operation when the Gap sensor is used and the reference position is adjusted with <#> on side hole tags. Print Error Sample Printing RFID tag errors when cut & print mode is set Be careful of white streaks. Back to top