TOP > Adjusting the Product > Flow of Printing Operations > Operations in Linerless Cutter Mode > Linerless Cutter Mode and Backfeed After Printing (Head Check Enabled) Linerless Cutter Mode and Backfeed After Printing (Head Check Enabled) Operation *1 The linerless sensor confirms the dispensing condition and the product does not perform the next operation until the label is dispensed. *2 The backfeed speed becomes 2 inches/sec (50.8 mm/sec) immediately after powering on the product, or more than 1 hour after completing a print operation or after completing a feed operation. • The figure above shows the reference position when the I-mark sensor is used. Timing Chart Back to top
