TOP > Adjusting the Product > Initializing the Product > List of Initial Values > [Printing] Menu [Printing] Menu Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized. • Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed. Setting Item Initial Value Initialized by User Reset/Initialized by Factory Reset [Media Type] Label Yes/Yes [Label Length] 203 dpi 3200 dots 305 dpi 4800 dots Yes/Yes [Label Width] 203 dpi 832 dots 305 dpi 1248 dots Yes/Yes [Auto Measure] Disabled Yes/Yes [Printing Mode] Use Ribbon Yes/Yes [Ribbon Near End] Enabled Yes/Yes [Speed] 4 ips Yes/Yes [Sensor Type] If [Print Mode] is set to [Dispenser], [Tear-Off], [Continuous], [Cutter], [Cut & Print] or [Partial cutter] Gap If [Print Mode] is set to [Linerless cutter] or [Linerless tearoff] None Yes/Yes [Auto-mode] Enabled Yes/Yes [Print Mode] If no option is installed Tear-Off If dispenser unit is installed Dispenser If cutter unit is installed Cutter If linerless cutter unit is installed Linerless cutter Yes/Yes [Backfeed] If [Print Mode] is set to [Continuous] None If [Print Mode] is set to [Tear-Off], [Cutter], [Partial cutter], [Linerless cutter], or [Linerless tearoff] Before If [Print Mode] is set to [Dispenser] or [Cut & Print] After Yes/Yes [Eject Cut] Off Yes/Yes [Darkness Range] A Yes/Yes [Darkness] 5 Yes/Yes [Imaging] [Vertical] 0 dot Yes/Yes [Horizontal] 0 dot Yes/Yes [Advanced] [Calibrate] [Auto-calibration] - - [GAP Levels] Value adjusted by the factory No/No [GAP Slice Level] Auto No/No [I-Mark Levels] Value adjusted by the factory No/No [I-Mark Slice Level] Auto No/No [Head Check] Off Yes/Yes [Head Check Mode] Always Yes/Yes [Every Page] 1 Yes/Yes [Check Media Size] Disabled Yes/Yes [Adjustments] [Offset] 0 dot No/No [Pitch] 0 dot No/No [Darkness Adjust] 50 No/No [Label Top Sensor] 0 dot No/No [Start Online] Enabled Yes/Yes [Feed After Error] Disabled Yes/Yes [Feed At Power On] Disabled Yes/Yes [Label Waste Prevention] [Enable] Disabled Yes/Yes [Registered Label Length] 203 dpi 3200 dots 305 dpi 4800 dots Yes/Yes [Finisher Feed] 0 dot (Standard) Yes/Yes [Paper End] Using I-mark Yes/Yes [Prioritize] Commands Yes/Yes [Reprint] Disabled Yes/Yes [Print End Position] 0 dot Yes/Yes Back to top