TOP > Adjusting the Product > Initializing the Product > List of Initial Values > [Printing] Menu [Printing] Menu Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized. • Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed. Setting Item Initial Value Initialized by User Reset Initialized by Factory Reset PW208NX PW208mNX [Label Length] 1760 dot Yes Yes [Label Width] 440 dot Yes Yes [Auto Measure] Disabled Yes Yes [Speed] 4 ips Yes Yes [Print Mode] Tear-off Yes Yes [Sensor Type] I-mark None Yes Yes [Peeling Setting] (PW208NX only) [Backfeed] Before - Yes Yes [Sensor Type] I-mark - No No [Darkness Range] A Yes Yes [Darkness] 5 Yes Yes [Imaging] [Vertical] 0 dot Yes Yes [Horizontal] 0 dot Yes Yes [Advanced] [Calibrate] [Auto-calibration] Gap + I-Mark I-mark No No [GAP Levels] Value adjusted by the factory. No No [I-Mark Levels] Value adjusted by the factory. No No [Gap Sensor](PW208NX only) - - - [Emission Level] 3 No No [Receiving Level] 64 No No [Slice Level] 0.0 V (Auto) No No [I-Mark Sensor] - - - [Emission Level] 6 No No [Receiving Level] 64 No No [Slice Level] 0.0 V (Auto) No No [Head Check] All Yes Yes [Head Check Mode] Always Yes Yes [Every Page] 1 Yes Yes [Check Media Size] Disabled Yes Yes [Adjustments] [Offset] 0 dot No No [Pitch] 0 dot No No [Darkness Adjust] 50 No No [Start Online] Enabled Yes Yes [Feed After Error] Disabled Yes Yes [Feed At Power On] Disabled Yes Yes [Finisher Feed] 0 dot Yes Yes [Paper End] (PW208NX only) Using I-mark - Yes Yes [Prioritize] Commands Yes Yes [Reprint] Disabled Yes Yes [Print End Position] 0 dot Yes Yes [Dispenser Mode] Auto None Yes Yes Back to top