Error Message 1131 (Exceed Address Error) (CL4NX Plus Only)

When there is an error with the product, the error message appears on the screen.

Check the cause and countermeasure, and then take appropriate action.

　

To clear the error:

Press the button (RETRY), and then execute the retry/release operation set in [Retry Mode], or press the button (ABORT).

Retry Mode

To cancel an entire print job, open and close the top cover to switch the product to Offline mode, and then press the button (CANCEL).

Cause and Countermeasure

ISO/IEC 15693 only Cause ◦ Tried to write the data to the memory which exceeds the address range. ◦ The memory does not exist in the memory block address where the data should be written. Countermeasure ◦ Check if the address size exceeds the maximum inlay capacity. ◦ Check the data size.

Contact your SATO technical support if the error cannot be resolved.

Contact Information for When You Are in Trouble

• You cannot use an RFID tag that has caused an RFID tag error. An error message is printed on the RFID tag that caused the error.