[Check Media Size]

Enable or disable media size check.

Appears only if you have selected [Gap] or [I-Mark] in the [Sensor Type] menu.

By enabling this function, "Media Error" is shown if either of the following conditions applies:

•	If the media is more than 3 mm (0.12") longer than the media length specified with the media size <A1> command.

•	If the current media feed length is more than 3 mm (0.12") longer than the media length fed for the first time after this function is enabled.

• When using this function with media that has a gap of more than 3 mm (0.12"), the Label Waste Prevention function cannot be used.