[Registered Label Length]

To accurately execute the Label Waste Prevention function, register the length of the media you are using. If you do not register the media length, the second and following labels may be fed blank.

If you set it to 0 (Auto), the label length is measured automatically while the first label is being printed.

Appears when the following conditions are met.

•	[Label Waste Prevention] > [Enable] is enabled.

•	On the [Printing] > [Media Type] menu, [Label] is selected.

•	On the [Printing] > [Sensor Type] menu, [Gap] or [I-Mark] is selected.

Set a value for the media length that includes the liner.

The setting range varies depending on the print resolution of the product.

The setting range is as follows:

Resolution	Setting range
203 dpi (1 dot = 0.125 mm (0.0049"))	0 to 20000 dots
305 dpi (1 dot = 0.083 mm (0.0033"))	0 to 18000 dots

• Register the length of the label and do not set it to 0 (Auto) in the following conditions: ◦ When using media with I-marks positioned at the leading edge of the label, and the I-mark and the back side pre-printing are positioned in the center of the horizontal direction of the label ◦ When using media with perforated lines in the center of the horizontal direction of the label ◦ When using media with holes in the center of the horizontal direction of the label ◦ When printing continuously across 2 or more labels • You can change the units to dots, " (inches), or mm in the [System] > [Regional] > [Unit] menu. • If you change to labels with a different length, set the label length again in [Registered Label Length] or set it to 0 (Auto). If [Registered Label Length] is different from the actual media length, printing may become misaligned. • The changes to this setting are linked and are changed with the settings in the [Tools] > [Media Startup] menu.