[Tools] Menu

Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized.

• Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed.

Setting Item				Initial Value	Initialized by User Reset/Initialized by Factory Reset
[Media Startup]				-	-
[Media Profiles Editing]				-	-
	[Media Profiles Registration]
		[Media Profile 1] to [Media Profile 5]		Non-registered	No/Yes
	[Delete Media Profiles]
		[Media Profile 1] to [Media Profile 5]		Non-registered	No/Yes
[Test Print]
	[Factory]
		[Label Width]		Large	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Configure List]
		[Category]		All	Yes/Yes
		[Label Width]		Small	-
		[Label Length]		203 dpi 800 dots 305 dpi 1200 dots	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Configure QR]
		[Category]		All	Yes/Yes
		[Label Width]		Small	-
		[Label Length]		203 dpi 800 dots 305 dpi 1200 dots	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Paper Sensor]
		[Label Width]		Small	-
		[Label Length]		203 dpi 800 dots 305 dpi 1200 dots	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[BD Address]
		[Label Width]		Large	-
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Head Check]
		[Label Width]		203 dpi 832 dots 305 dpi 1248 dots	Yes/Yes
		[Label Length]		203 dpi 160 dots 305 dpi 240 dots	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
[HEX-Dump]
	[Hex Dump Mode]			Disabled	Yes/Yes
[Reset]				-	-
[Profiles]				-	No/No
	[Start with]			-	Yes/Yes
[Service]
[Factory]
[Wi-Fi Site Survey]				-	-
[Install Certificates]				-	Yes/Yes
[Delete Certificates]				-	Yes/Yes
[Clone]				-	-
[AutoClone Setting]
	[Enable]			Disabled	Yes/Yes
[Logging Function]
	[Enabled]			Disabled	No/Yes
	[Additional Log]
			[Wi-Fi Log Enable]	Disabled	No/No
	[Save]			-	-
	[Remove]			-	-
[Startup Guide]				Enabled	No/Yes