[Tools] Menu

Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized.

• Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed.

Setting Item					Initial Value		Initialized by User Reset	Initialized by Factory Reset
					PW208NX	PW208mNX
[Test Print]
	[BD Address]
		[Pitch]			0 dot		No	No
		[Offset]			0 dot		No	No
		[Darkness Adjust]			50		No	No
	[Factory]
		[Pitch]			0 dot		No	No
		[Offset]			0 dot		No	No
		[Darkness Adjust]			50		No	No
	[Configure List]
		[Label Length]			800 dot		Yes	Yes
		[Pitch]			0 dot		No	No
		[Offset]			0 dot		No	No
		[Darkness Adjust]			50		No	No
	[Configure QR]
		[Label Length]			800 dot		Yes	Yes
		[Pitch]			0 dot		No	No
		[Offset]			0 dot		No	No
		[Darkness Adjust]			50		No	No
	[Paper Sensor]
		[Label Length]			800 dot		Yes	Yes
		[Pitch]			0 dot		No	No
		[Offset]			0 dot		No	No
		[Darkness Adjust]			50		No	No
[HEX-Dump]
	[Hex Dump Mode] 1				Disabled		Yes	Yes
[Clone]					Excl. WiFi/IP/BT		No	No
[Logging Function]
	[Enabled]				Disabled		No	Yes
	[Additional Log]
		[Wi-Fi Log Enable]			Disabled		No	Yes
	[Save]				-		-	-
	[Remove]				-		-	-
[Save Print Image]					Disabled		Yes	Yes

¹It will also be initialized if [Internal data] is selected under [Reset] > [Select] .