[Tools] Menu

Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized.

• Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed.

Setting Item					Initial Value	Initialized by User Reset	Initialized by Factory Reset
[Test Print]
	[Factory]
		[Label Width]			Large	Yes	Yes
		[Pitch]			0 dot	No	No
		[Offset]			0 dot	No	No
		[Darkness Adjust]			50	No	No
	[Configure List]
		[Label Width]			Small	-	-
		[Label Length]			203 dpi 800 dots 305 dpi 1200 dots	Yes	Yes
		[Pitch]			0 dot	No	No
		[Offset]			0 dot	No	No
		[Darkness Adjust]			50	No	No
	[Configure QR]
		[Label Width]			Small	-	-
		[Label Length]			203 dpi 800 dots 305 dpi 1200 dots	Yes	Yes
		[Pitch]			0 dot	No	No
		[Offset]			0 dot	No	No
		[Darkness Adjust]			50	No	No
	[Paper Sensor]
		[Label Width]			Small	-	-
		[Label Length]			203 dpi 800 dots 305 dpi 1200 dots	Yes	Yes
		[Pitch]			0 dot	No	No
		[Offset]			0 dot	No	No
		[Darkness Adjust]			50	No	No
	[Head Check]
		[Label Width]			203 dpi 832 dots 305 dpi 1248 dots	Yes	Yes
		[Label Length]			203 dpi 160 dots 305 dpi 240 dots	Yes	Yes
		[Pitch]			0 dot	No	No
		[Offset]			0 dot	No	No
		[Darkness Adjust]			50	No	No
[HEX-Dump]
	[Hex Dump Mode]				Disabled	Yes	Yes
[Reset]
[Profile]
	[Delete]				-	-	-
	[Load]				-	-	-
	[Save]				-	-	-
	[Start with]				-	Yes	Yes
[Certificates]					-	Yes	Yes
[Clone]					Excl. LAN/Wi-Fi/IP	-	-
[Support Info]					-	-	-
[Startup Guide]					Disabled	No	Yes