[Printing] Menu

Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized.

• Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed.

Setting Item				Initial Value	Initialized by User Reset	Initialized by Factory Reset
[Label Length]				203 dpi 20000 dots 305 dpi 18000 dots	Yes	Yes
[Label Width]				203 dpi 832 dots 305 dpi 1248 dots	Yes	Yes
[Auto Measure]				Disabled	Yes	Yes
[Printing Mode]				Use Ribbon	Yes	Yes
[Ribbon Near End]				Enabled	Yes	Yes
[Speed]				203 dpi 4 ips 305 dpi 4 ips	Yes	Yes
[Sensor Type]				I-Mark	Yes	Yes
[Print Mode]				Dispenser	Yes	Yes
[Backfeed]
	[Backfeed]			Before (If [Print Mode] is set to [Dispenser]) None (If [Print Mode] is set to [Continuous] or [Continuous-Standalone])	Yes	Yes
	[Backfeed Timing]			0 ms (If [Backfeed] is set to [After])	No	Yes
[Darkness Range]				A	Yes	Yes
[Darkness]				5	Yes	Yes
[Imaging]
	[Vertical]			0 dot	Yes	Yes
	[Horizontal]			0 dot	Yes	Yes
[Advanced]
	[Calibrate]
		[Auto-calibration]		Gap + I-Mark	-	-
		[GAP Levels]		Value adjusted by the factory.	No	No
		[GAP Slice Level]		Auto	No	No
		[I-Mark Levels]		Value adjusted by the factory.	No	No
		[I-Mark Slice Level]		Auto	No	No
	[Head Check]			All	Yes	Yes
	[Head Check Mode]			Always	Yes	Yes
	[Every Page]			1	Yes	Yes
	[Check Media Size]			Enabled	Yes	Yes
	[Check Area Size]
		[Check Area Size]		Enabled	Yes	Yes
		[Paper Size]		Enabled	Yes	Yes
		[Over Size]		Enabled	Yes	Yes
	[Page Clipping Mode]			Disabled	Yes	Yes
	[Adjustments]
		[Offset]		0 dot	No	No
		[Pitch]		0 dot	No	No
		[Darkness Adjust]		50	No	No
	[Start Online]			Enabled	Yes	Yes
	[Feed After Error]			Disabled	Yes	Yes
	[Feed At Power On]			Disabled	Yes	Yes
	[Finisher Feed]			0 dot (Standard)	Yes	Yes
	[Paper End]			Using Gap	Yes	Yes
	[Prioritize]			Commands	Yes	Yes
	[Reprint]			Disabled	Yes	Yes
	[Print End Position]			0 dot	Yes	Yes
	[Label Near End]			Enabled	Yes	Yes
	[Receive After Reset]			Disabled	Yes	Yes
	[Feed After Error Message]			Enabled	Yes	Yes
	[Job Name Display]			Disabled	Yes	Yes
	[Virtual Sensor Position]			203 dpi 708 dots 305 dpi 1062 dots	Yes	Yes
	[Print Start Position]			0 mm (0")	Yes	Yes
	[Ribbon Near End Level]			Standard	Yes	Yes
	[Paper End Output Timing]			Print Standard	Yes	Yes
	[Ribbon End Sensor]			Disabled	No	Yes
	[Label End Sensor]			Disabled	No	Yes