TOP > Various Settings of the Product > The [SETTINGS] Menu > [Applications] Menu > [SEPL] [SEPL] To use SEPL as a printer command, set the following items: [Home Reference]Adjust the print reference position by specifying the offset position in the horizontal and vertical directions.The setting items are as follows:[Horz. Offset]Specify the offset position in the horizontal direction.The setting range is from 0 to 400 dots. • The length of 1 dot varies depending on the print resolution of the product.◦ 203 dpi : 1 dot = 0.125 mm (0.0049")◦ 305 dpi : 1 dot = 0.083 mm (0.0033")• You can change the units to dots, " (inches), or mm in the [System] > [Regional] > [Unit] menu.[Vert. Offset]Specify the offset position in the vertical direction.The setting range is from 0 to 400 dots. • The length of 1 dot varies depending on the print resolution of the product.◦ 203 dpi : 1 dot = 0.125 mm (0.0049")◦ 305 dpi : 1 dot = 0.083 mm (0.0033")• You can change the units to dots, " (inches), or mm in the [System] > [Regional] > [Unit] menu.[Label Rotation]Set the page orientation for label printing.The label size set in the product is used as a reference of rotation.The options are as follows:0 degreeLabels are printed in portrait orientation.180 degreeLabels are printed in inverse-portrait orientation.[Memory Device]Select the product's memory space in which to store forms, graphics and fonts.The options are as follows:Internal RAMUse the product's internal RAM. The data will be lost if the product is powered off.Internal FLASHUse the product's internal ROM.Rear USBUse the USB connector on the back of the product.Internal USBUse the internal USB connector. • Be sure to perform a virus check on the USB memory before connecting it to the product. SATO Corporation shall not be held responsible for any product malfunctions caused by a virus spread via USB memory.[Sim. 300 DPI Head]When you are using the product with 305 dpi resolution, enable or disable 300 dpi simulation mode.Enable 300 dpi simulation mode. The sizes and positions of objects such as lines, boxes and barcodes in the print data are automatically adjusted to the equivalent 300 dpi sizes and positions for printing.Disable 300 dpi simulation mode.Related TopicsSettings Mode OperationsSetting Value Input[Unit] Back to top