[Tools] Menu

Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized.

• Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed.

Setting Item				Initial Value	Initialized by User Reset/Factory Reset
[Test Print]
	[Factory]
		[Label Width]		[Large]	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Configure List]
		[Label Width]		[Small]	-
		[Label Length]		800 dot	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Configure QR]
		[Label Width]		[Small]	-
		[Label Length]		800 dot	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Paper Sensor]
		[Label Width]		[Small]	-
		[Label Length]		800 dot	Yes/Yes
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[BD Address]
		[Label Width]		[Large]	-
		[Pitch]		0 dot	No/No
		[Offset]		0 dot	No/No
		[Darkness Adjust]		50	No/No
	[Head Check]
		[Label Width]		832 dot	Yes/Yes
		[Label Length]		120 dot	Yes/Yes
		[Pitch]		0	No/No
		[Offset]		0	No/No
		[Darkness Adjust]		50	No/No
[HEX-Dump]
	[Hex Dump Mode]			[Disabled]	Yes/Yes
[Reset]				-	-
[Profiles]				-	No/No
[Service]
[Factory]
[Wi-Fi Site Survey]				-	-
[Install Certificates]				-	Yes/Yes
[Delete Certificates]				-	Yes/Yes
[Clone]				-	-
[Logging Function]
	[Enabled]			[Disabled]	No/Yes
	[Save]			-	-
	[Remove]			-	-
[Startup Guide]				[Enabled]	No/Yes