Charging Using 12-60V DC Power Supply (Option)

• Do not power on or off the product, or connect or disconnect the power cord while your hands are wet. Doing so could cause an electric shock.

Tools and screws to prepare • Flathead screwdriver • Phillips screwdriver (to permanently install a 12-60V DC power supply) • 4 screws (to permanently install a 12-60V DC power supply)

1.	To permanently install a 12-60V DC power supply, put the screws you prepared in the 4 mounting holes (1) to mount it.

• We assume no responsibility for the product dropping due to insufficient mounting strength or your carelessness. The customer is responsible for confirming the condition of the installation location.

• The customer must prepare the Phillips screwdriver and mounting screws.

2.	Use the flathead screwdriver to loosen the 2 screws (2) on top of the connector, insert the positive (+) and negative (-) wires of your power supply, and then tighten the screws.

• The customer must prepare the flathead screwdriver. • Connect the positive (+) to the right side and the negative (-) to the left side. • Use 12 to 22 AWG wires for the connections. We also recommend that the wire be less than 1.5 m (4.92 ft) long. • Tighten the wires so they do not come out if you lightly pull on them. If they are too tight, the wires could be cut off.

3.	Insert the connector into the receptacle (3) of the 12-60V DC power supply, and tighten the 2 screws (4).