TOP > Adjusting the Product > Flow of Printing Operations > Operations in Linerless Mode > Linerless Mode, Backfeed Before Printing, with Media Sensor Enabled Linerless Mode, Backfeed Before Printing, with Media Sensor Enabled Operation *1 The dispenser sensor checks the presence of labels; and the product does not perform the next operation until manual cutting is performed. *2 Adjustment of the feed position is only done after moving to the start position using the various adjustment functions. If no adjustment is done, then start printing without a feed operation. The direction of feed changes depending on the adjustments. • The figure above shows the reference position when the I-mark sensor is used. Timing Chart (Without Head Check) Timing Chart (With Head Check) Back to top
