[Printing] Menu

Initial values refer to the values set for the product when it was shipped from the factory. If you reset the product, the values set in the product are initialized. The table below shows the initial value of each setting item and whether it would be initialized.

• Normally, it is not necessary to perform the initialization. Doing an initialization removes all the product's settings that the customer changed.

Setting Item			Initial Value	Initialized by User Reset/Factory Reset
[Label Length]			8000 dot	Yes/Yes
[Label Width]			832 dot	Yes/Yes
[Auto Measure]			[Disabled]	Yes/Yes
[Speed]			4 ips	Yes/Yes
[Print Mode]			[Tear-Off]	Yes/Yes
[Backfeed]			If [Print Mode] is set to [Continuous] [None] If [Print Mode] is set to [Tear-Off], [Dispenser], or [Linerless tearoff] [Before]	Yes/Yes
[Sensor Type]			If [Print Mode] is set to [Dispenser], [Tear-Off], or [Continuous] [Gap] If [Print Mode] is set to [Linerless tearoff] [I-Mark]	Yes/Yes
[Darkness Range]			A	Yes/Yes
[Darkness]			5	Yes/Yes
[Imaging]
	[Vertical]		0 dot	Yes/Yes
	[Horizontal]		0 dot	Yes/Yes
[Advanced]
	[Calibrate]
		[Auto-calibration]	-	-
		[GAP Levels]	Value adjusted by the factory	No/No
		[GAP Slice Level]	Auto	No/No
		[I-Mark Levels]	Value adjusted by the factory	No/No
		[I-Mark Slice Level]	Auto	No/No
	[Head Check]		[Off]	Yes/Yes
	[Head Check Mode]		[Always]	Yes/Yes
	[Every Page]		1	Yes/Yes
	[Check Media Size]		[Disabled]	Yes/Yes
	[Adjustments]
		[Offset]	0 dot	No/No
		[Pitch]	0 dot	No/No
		[Darkness Adjust]	50	No/No
	[Start Online]		[Enabled]	Yes/Yes
	[Feed After Error]		[Disabled]	Yes/Yes
	[Feed At Power On]		[Disabled]	Yes/Yes
	[Finisher Feed]		0 dot ([Standard])	Yes/Yes
	[Paper End]		[Using I-mark]	Yes/Yes
	[Prioritize]		[Commands]	Yes/Yes
	[Reprint]		[Disabled]	Yes/Yes
	[Print Control]		[Balance]	Yes/Yes
	[Print End Position]		0 dot	Yes/Yes