[Tools] Menu

The initial value refers to the setting value of the product when it was shipped from the factory. The table below shows the initial value of each setting item.

Setting Item					Initial Value
[Test Print]
	[Factory]
		[Label Width]			Large
		[Pitch]			0 dot
		[Offset]			0 dot
		[Darkness Adjust]			50
	[Configure List]
		[Category]			All
		[Label Width]			Small
		[Label Length]			660 dots
		[Pitch]			0 dot
		[Offset]			0 dot
		[Darkness Adjust]			50
	[Configure QR]
		[Category]			All
		[Label Width]			Small
		[Label Length]			660 dots
		[Pitch]			0 dot
		[Offset]			0 dot
		[Darkness Adjust]			50
	[Paper Sensor]
		[Label Width]			Small
		[Label Length]			660 dots
		[Pitch]			0 dot
		[Offset]			0 dot
		[Darkness Adjust]			50
	[BD address]
		[Label Width]			Large
		[Pitch]			0 dot
		[Offset]			0 dot
		[Darkness Adjust]			50
[HEX-Dump]
	[Hex Dump Mode]				Disabled
[Profiles]
	[Delete]				-
	[Load]				-
	[Save]				-
	[Save as]				-
	[Start with]				-
[Wi-Fi Site Survey]					-
[Install Certificates]					-
[Delete Certificates]					-
[Clone]					-
[Startup Guide]					Enabled