Cleaning Using the Cleaning Kit (with Optional Linerless Kit)

View the video here (it has no audio).

The cleaning procedure using the cleaning kit is as follows:

• Never use organic solvents, such as thinner and benzine to clean the product.

• For details on the cleaning kit, refer to the manual attached to the cleaning kit.

　

View the video below for the procedure.

1.	Make sure that the product is powered off, and disconnect the power cord from the AC outlet or remove the optional battery.

2.	Press the cover open button (1) to open the top cover (2).

3.	Remove the media if it is already loaded.

4.	Clean the dirt off of the print head (3) and two rollers (4) using a cotton swab dabbed with cleaning liquid.

• The print head and its surroundings are hot after printing. Wait until the product cools down. • Touching the edge of the print head with your bare hand could cause injury.

5.	Clean the sensor (5) using an air duster.

6.	Clean the dirt off of the platen roller (6) and feed roller (7) using a cotton cloth dabbed with cleaning liquid.

7.	Clean the dirt off of the liner sensor (8) and dispenser sensor (9) using a cotton cloth dabbed with cleaning liquid.

8.	Lift the dispenser frame (10) on the front side of the product () and tilt it toward the front ().

9.	Clean the dirt off of the three rollers (11) using a cotton cloth dabbed with cleaning liquid.

10.	Reload the media if you removed it in step 3.

11.	Close the dispenser frame.

---

Related Topics

Loading the Media