[Battery] Menu

The following settings are available in the [Battery] menu:

[Health]

Shows the battery condition.

The condition is shown as [Good], [Replace], or [Poor].

You cannot change the setting.

[SOH]

Displays the battery health (maximum capacity) as a numeric value.

Based on the assumption that the battery’s full charge when new is 100%, this indicates the maximum charge currently attainable.

You cannot change the setting.

[Cycle Counts]

Shows the cycle count (charge/discharge cycle).

You cannot change the setting.

[Eco Charge]

Set up the Eco Charge function.

The Eco Charge function is designed to extend the battery life by keeping the after-charged volume of the battery a little lower than the fully charged volume, thus delaying the degree of deterioration.

The options are as follows:

Enabled

Enable the Eco Charge function.

Disabled

Disable the Eco Charge function.

• When using the product being set on the 1Bay Charging Cradle (option), [Enabled] is recommended.

[Full Charge Power-Off]

Set up the product's power-off function after charging is complete.

While the product is paused in Online/Offline screen, the product powers off 3 seconds after it completes charging.

The options are as follows:

Enabled

The product powers off automatically after it completes charging.

Disabled

The product does not power off automatically after it competes charging.

Conditions to disable the Full-Charge Power-off function

◦	While the product is printing or feeding the media.

◦	While the product button is being used.

◦	During Adjustments or Settings mode.

◦	While the product receives the data.

◦	If the temperature in the product exceeds the tolerance range (error 1065).

◦	When an AC adapter is removed.

• When using the product being set on the 1Bay Charging Cradle (option), [Disabled] is recommended.

[Voltage]

Shows the battery voltage.

• When the battery eliminator (option) is installed, the voltage of the dummy battery is shown.

[Capacity]

The remaining battery level, given the battery's initial fully charged capacity is 100%, is displayed.

[Temp]

Shows the battery temperature.

[Battery Type]

Shows the type of battery in use.

[Serial]

Shows the battery serial number.

[Battery Log]

Displays the usage history of the battery information.

Battery Log0

Battery Log1

Battery Log2

Battery Log3

Battery Log4

Battery Log5

[Battery Log0]displays the current battery usage history. When the battery is replaced and the counter is cleared, the values that were displayed in [Battery Log0] move to [Battery Log1], and the values that were displayed in [Battery Log1] move to [Battery Log2].

[Battery Log0]

Displays information about the batteries that have been used.

Serial

Displays the battery serial information.

SOH

Displays the battery health (maximum capacity) as a numeric value.

Based on the assumption that the battery’s full charge when new is 100%, this indicates the maximum charge currently attainable.

Cycle Counts

Displays the battery cycle count (charge/discharge cycles).

DateTime

Displays the date and time when the log was last updated. The date and time stored in the printer are used for the update timestamp.

---

Related Topics

Item Selection

Setting Value Input or Selection