S84NX/86NX Operator Manual
SATO

MENU

MENU

  • TOP (Table of Contents)
  • Getting Started
  • Searching from Category
  • Searching by Function Names
  • Searching According to What You Want to Do
  • Troubleshooting
  • Support and Warranty
Close
TOP > Loading Media and Ribbon > When to Replace Media and Ribbon > Conditions That Trigger Ribbon End (Thermal Transfer Only)
Conditions That Trigger Ribbon End (Thermal Transfer Only)
Ribbon end error is detected by the ribbon sensor in the ribbon supply spindle. Ribbon end error occurs when the product detects that the ribbon in the ribbon supply spindle has not moved (rolled) more than 32 mm (1.26") after feeding the media.
 
Following are the behaviors when detecting the ribbon end according to the remaining print job.
•
When the amount of printing remaining is 12 mm (0.47") or more, the product generates a ribbon error immediately after detection.
•
When the amount of printing remaining is less than 12 mm (0.47"), the product generates a ribbon error after printing is completed.
•
When you have selected [Continuous] in the [Print Mode] menu as well as selecting [None] in the [Sensor Type] menu, or if you have selected [Linerless] in the [Print Mode] menu, then regardless of the amount of printing remaining, the product generates a ribbon error immediately after detection.
•
When feeding, the product generates a ribbon error immediately after detection.

Related Topics
Operations When Errors Occur
Error Message 1009 (Ribbon End)

Back to top

© 2022 SATO Corporation