[Advanced]

[Calibrate]

[Head Check]

[Head Check Mode]

[Every Page]

[Check Media Size]

[Adjustments]

[Start Online]

[Feed After Error]

[Feed At Power On]

[Finisher Feed]

[Paper End]

[Head Base Position]

[Prioritize]

[Reprint]

[Print End Position]

[Label Near End]

Set detailed sensor operation and print motion.

The setting items are as follows:

Calibrate

Adjust the media sensor.

Head Check

Check if there is a broken element of the print head.

Head Check Mode

Set the mode for head check.

◦	Appears if you have selected [All] or [Barcode] in the [Head Check] menu.

Every Page

Set the interval for head check.

◦	Appears if you have selected [Every Page] in the [Head Check Mode] menu.

Check Media Size

Enable or disable media size check.

◦	Appears if you have selected [Gap] or [I-Mark] in the [Sensor Type] menu.

Adjustments

Correct the offset value, print position and print darkness.

Start Online

Set whether to power on the product in Online mode.

Feed After Error

Set whether to automatically feed the media when recovering from an error.

Feed At Power On

Set whether to automatically feed the media when the product is powered on.

Finisher Feed

Set the length to feed after printing.

Paper End

Select the sensor for sensing the paper end.

Head Base Position

Set the edge position for printing.

Prioritize

For product settings, set whether to prioritize the settings that are done through the product or through commands.

Reprint

Enable or disable the reprint function.

Print End Position

Adjust the media stop position or cut position when [Sensor Type] is set to [None].

Label Near End

Enable or disable the warning when the media is about to run out.

*This feature is supported on products from serial number 6B~ and above. Although this setting appears on products with serial number 6A~ or below, it is not supported.