[SEPL]

To use SEPL as a printer command, set the following items:

[Home Reference]

Adjust the print reference position by specifying the offset position in the horizontal and vertical directions.

The setting items are as follows:

[Horz. Offset]

Specify the offset position in the horizontal direction.

The setting range is from 0 to 400 dots.

• The length of 1 dot is 0.083 mm (0.0033"). • You can change the units to dots, " (inches), or mm in the [System] > [Regional] > [Unit] menu.

[Vert. Offset]

Specify the offset position in the vertical direction.

The setting range is from 0 to 400 dots.

• The length of 1 dot is 0.083 mm (0.0033"). • You can change the units to dots, " (inches), or mm in the [System] > [Regional] > [Unit] menu.

[Memory Device]

Select the product's memory space in which to store forms, graphics and fonts.

The options are as follows:

Internal RAM

Use the product's RAM. The data will be lost if the product is powered off.

Internal FLASH

Use the product's flash memory.

USB1

Use the upper USB connector on the back of the product.

USB2

Use the lower USB connector on the back of the product.

USB3

Use the internal USB connector.

• Be sure to perform a virus check on the USB memory before connecting it to the product. SATO Corporation shall not be held responsible for any product malfunctions caused by a virus spread via USB memory.

[Sim. 300 DPI Head]

Enable or disable 300 dpi simulation mode.

Enable 300 dpi simulation mode. The sizes and positions of objects such as lines, boxes and barcodes in the print data are automatically adjusted to the equivalent 300 dpi sizes and positions for printing.

Disable 300 dpi simulation mode.

---

Related Topics

Settings Mode Operations

Setting Value Input

[Unit]