S84NX/86NX Operator Manual
SATO

MENU

MENU

  • TOP (Table of Contents)
  • Getting Started
  • Searching from Category
  • Searching by Function Names
  • Searching According to What You Want to Do
  • Troubleshooting
  • Support and Warranty
Close
TOP > Adjusting the Product
Adjusting the Product
Printable Area
Media Sensor Positions and Media Stop Positions
Flow of Printing Operations
Printing Operations
Operations in Continuous Mode
Operations in Dispenser Mode
Operations in Dispense & Print Mode
Operations in Linerless Mode
Operations for RFID Write (S84NX Only)
Operations When the Barcode Check Function Is Enabled
Adjusting the Base Reference Point
About the Base Reference Point
Adjusting the Print Position
Adjusting the Dispenser Stop Position
Adjusting the Print Quality
Adjusting the Print Darkness
Adjusting the Print Speed
Adjusting the Product's Buzzer Volume
Adjusting the Head Pressure Balance
Print Head Balance
Pressure Balance Setting
Adjusting the Head Position
Left - Right Pressure Balance Setting
Front - Rear Head Alignment
Adjusting the Ribbon Tension Balance
RFID Settings (S84NX Only)
Usable RFID Standards
Configuring the Product to Encode Inlays
Loading the RFID Tag Model
Printing RFID Tag Errors
RFID Printing Tips
Configuring Optional Barcode Check Function
Basic Specifications of the Barcode Check Function
Setting Up the Barcode Checker
Enabling the Barcode Check
Restrictions for the Barcode Check Function
Initializing the Product
Procedures for Initializing
List of Initial Values

Back to top

© 2022 SATO Corporation